Sinks

Novagent sinks made of Polypropylene PP are theideal match for laboratory benchtops. Suppliedwith 1½" male threaded PP outlet and standpipe.

Technical details:

Internal dimensions 400 x 400 x 250 mm

Waste connection 1½"

Constant wall-thickness of 3,8 mm due to injectionmoulding

High chemical resistance

Special groove in the flange keeps the water seal in position

Suitable for drop-on as well as for undermount installation

In case of drop-on installation, the flange sits very neat onthe worksurface

Easy to install

Stackable

Maximum resistance to all chemicals

Made of acid resistant Polypropylene. Polypropylene PP is an ideal material for solving corrosion problems thanks to its excellent resistance to acids, alkalis and some chemicals. They also have thermal resistance against liquids whose temperature has increased during the experiment and have a long service life.

Colors: White, Black, Blue, Grey

Perfect Design

It is also possible to reach special dimensions according to the requirements and desired dimensions of the laboratories in the washbasins, which gain a more pleasant appearance with its rounded edges and corner lines. Since they are produced in a single mold without joints, leaks in the sink are reduced to a minimum. There are single and double sink types according to the possibilities of the area to be used. Some sinks have a discharge system with a waste section in the middle or corner. With their perfect design, uniform drainage is allowed at all points inside the sink and sink. Moreover, it is possible to reach products in different colors.

Cleaning and Maintenance

Polypropylene material is resistant to most chemicals used in the laboratory. Due to the properties of the material, contaminants do not easily adhere to PP. It can be easily cleaned with water or general cleaning agents. In case of heavy contamination, it is removed with ethanol or acetone. Abrasive cleaners should not be used during cleaning.